Why is my chain not spinning on my chainsaw?

Why is my chain not spinning on my chainsaw?

If your chainsaw blade will not rotate, the chain may be tensioned too tight. If the chain is too tight, the blade may not spin when the throttle is engaged, which can cause damage to the clutch or other associated parts. Keep in mind that the tension of the chain will change with heat.

What happens if you put a chainsaw chain on backwards?

Unfortunately the chain will go on either way, but if you put it on backwards, it will not cut. Remember, when holding the chainsaw, the cutting portion of the blade should be facing away from you, traveling from the back of the chainsaw to the front tip of the chainsaw.

How tight should a chainsaw chain be?

A properly-tensioned chainsaw chain should still be just a little loose on the chainsaw guide bar, but the chain needs to be tight enough that you can’t pull the drive links out of the bar nose.

How do you untangle a thick chain?

Place the chain on a hard, smooth, nonporous surface, such as glass, if the straight pin trick doesn’t work by itself. Apply a few drops of baby oil or mineral oil to the kinks, and repeat the pulling process with the pins. These oils lubricate the chain, helping ease out particularly stubborn kinks.

Can you over tighten a chainsaw chain?

This simple maintenance task is easy to perform and necessary to keep your chainsaw running safely. There is a tension screw located near the base of the bar on the chainsaw. To tighten the chain, turn it clockwise, and to loosen turn it counterclockwise. Don’t over-tighten the chain as this could cause it to break.

How Loose Should a chainsaw chain be?

Why does my chainsaw chain keep loosening?

This one comes down to physics. When metal gets warmer, it expands. When you’re using your chainsaw, as the chain heats up, it will literally get larger. This is probably the most common reason that a chainsaw will start tight, and then get loose.

Can you straighten a chainsaw bar?

The chainsaw bar is the piece that extends from the chainsaw’s handle. The bar fits over the chain blade. Severely bent chainsaw bars need to be replaced. However, a mildly bent bar can be straightened by following a few simple steps.

How tight should a chainsaw blade be?

How to untangle a chain on a chainsaw?

Easy Way to Untangle a New Chainsaw Blade 1. Remove the tangled chain from the chainsaw. 2. Grasp the tangled chain by two opposite loops in the tangle, placing one loop in each hand. Allow the rest of the… 3. Increase the diameter of the loops as wide as possible, while still holding the loops

Is the blade on a chainsaw a blade?

Chainsaws do not have a blade but a chain made up of lots of little teeth with sharpened blades on them, and few situations are as frustrating as dealing with a length of razor-sharp metal teeth that won’t behave as intended.

Which is the lowest part of a chainsaw chain?

Because chainsaw chains are stiff, the dangling, lowest part will poke straight out like a board until it reaches a vertical position. You can guide its movement easily by using only your hands’ grasp on the loops. When what was the lowest part of the chain points straight upward, the loops in your hand will be beneath it.