Table of Contents
What is the setting for Scotts speedy green 2000?
per 1,000 square feet, set your Scott’s Speedy Green 2000 to 3.75. Set the knob at 7.0 to spread at 4.6 lbs. per 1,000 square feet.
What setting should I set my Scotts spreader?
For a pushed broadcast spreader, Scotts recommends a setting of 2 1/4 when overseeding and a bare-lawn setting of 4. For application with a handheld broadcast spreader, use a setting of 3 when overseeding and 4 when planting a bare lawn.
What setting do you put fertilizer spreader on?
Set your spreader so that it’s ¾ open when engaged. If, for example, the spreader is calibrated 1 to 20, set it at 15. Place eight pounds of Milorganite into the spreader’s hopper. This is about one-fifth bag, or 8 lbs., of Milorganite, which is equivalent to 24 cups.
What do the number settings on a Scotts spreader mean?
For fertilizer spreaders the numbers usually represent the amount of fertilizer that is to be applied over a specific square feet of land. On spreaders you can find numbers such as 5, 5 and a half or 18 and a half.
Can you spread topsoil with a Scotts spreader?
Topsoil is easily spread in small areas using a shovel and over larger areas using a push spreader or wheelbarrow. Applying the correct amount of topsoil to your lawn or garden will improve its fertility and drainage characteristics.
What do the settings on a spreader mean?
A spreader setting is the rate in which you apply product to your lawn. Each Jonathan Green product has recommended rates of application and coverage based on bag size. In general, the smaller you set your spreader setting the smaller the hole and the slower the material releases from the hopper.
How do you read the spreader settings?
Calibrating Your Spreader
- Divide 100 by the square foot the bag of fertilizer covers.
- Multiply the weight of the bag by this number.
- The answer is the amount of fertilizer needed to cover 100 sq. ft.
- Place this amount in the spreader.
- Mark off a 10 ft. x 10 ft. area.
- Apply using the suggested setting.
What do I choose for my Scotts Speedy Green 3000?
The Taltar Xtra bag does not specifically list setting for the Scotts Speedy Green 3000, but it does list the Scotts SpeedyGreen 2000 and its spreader settings.
What’s the spreader setting for Scott’s Speedy Green?
Almost all fertilizers, herbicides, insecticides, etc have treatments in amounts of so much product per 1000 square feet. So if you can figure out what your walking speed is then you know anytime you apply any product that calls for so much of it per 1000 square feet, you always set your spreader on this setting.
What should I Set my Scotts lawn spreader to?
For example, to spread material at 2.25 lbs. per 1,000 square feet, set your Scott’s Speedy Green 2000 to 3.75. Set the knob at 7.0 to spread at 4.6 lbs. per 1,000 square feet. Walk the spreader to a corner of the tarp and open the dispenser.
How big should Scotts Turf Builder Edge Guard set be?
Scotts turf builder edge guard DLX – set spreader to “4”. A 9/13th drill bit should fit tight/snugly inside the opening when handle is pressed. Those numbers aren’t how many pounds per 1,000.