Menu Close

What is a megohmmeter used for?

What is a megohmmeter used for?

Megohmmeters provide a quick and easy way to determine the condition of the insulation on wire, generators, and motor windings. A megohmmeter is an electric meter that measures very high resistance values by sending a high voltage signal into the object being tested.

How does a megohmmeter differ from an ohmmeter?

A megohmmeter is a special type of ohmmeter used to measure the electrical resistance of insulators. Essentially, both the high-pot and the megohmmeter do the same thing, but with vastly different outcomes. But, a megohmmeter gives the operator a measurement, while a high-pot takes action.

What does Megger mean?

/ (ˈmɛɡə) / noun. trademark an instrument that generates a high voltage in order to test the resistance of insulation, etc.

Can you apply a megohmmeter to electronics?

Megohmmeter measurements can now be more accurate, rapid and safer than ever before. A considerable number of electronics personnel working throughout the electrical industry are military trained. A technician uses a hand-cranked megohmmeter to check the insulation resistance of motor windings.

What are good megohmmeter readings?

Anything reading between 2 megohms and 1000 megohms is usually considered a good reading, unless other problems have been noted. Anything less than 2 megohms indicates an insulation problem.

What is the another name of Megger?

A Megohmmeter or insulation resistance tester is a special type of ohmmeter used to measure the electrical resistance of insulators.

What is a bad megger reading?

What is a bad reading on a Megger test? If the megger reads a resistance under 1 (1,000 ohms) on your meter after the initial 60-second interval, the cable has failed and the cable should be removed. If the megger reads a resistance between 1-1.25 on your meter, then the cable passes.

What does a Megohmmeter check?

The megohmmeter, or megger , is a measuring device that tests high electrical resistances. Typically these measurements are made on electrical wires and motor windings to test the insulation value of the wires. The prefix “meg” describes a numerical value of 1,000,000. In the case of an ohmmeter that value is also described in ohms.

What is Megger test and how is it performed?

A megger is an ohmmeter that measures resistance in the megohm scale. It’s also known as an insulation tester. To test a cable with a megger, you connect one probe to the outside of the cable and, with the power turned off, you touch the probe to the conducting wire at the point of connection.

What is Meg meter?

Re: Meg Ohm Meter A megaohm meter is a special type of ohm meter. A megaohm meter is a special type of ohm meter . Instead of using the little 1.5 volt battery to check for ohms like a traditional meter, it has circuitry that checks the ohms is the presence of either 500 or 1000 volts.