Table of Contents
Why is my washing machine light flashing?
End light flashing If the wash, rinse and spin function lights all flash at the same time, this would indicate a possible blockage in your filter or waste / drain pipe. We recommend checking your user manual as all models vary – you can also download your user manual here.
How do you reset a washing machine sensor?
To reset your washing machine, unplug it from the power outlet. Then, plug the washer cord back into the wall. Finally, open and close the washing machine door six times to send the reset signal to the system components.
What do you do when your washer stops mid cycle?
Try stopping the machine, draining the water and rearranging the laundry. The spinning cycle won’t start if the water hasn’t drained completely. Turn off your washing machine and check the drain hose and the pump filter. The hose shouldn’t be bent or clogged.
Why is my washing machine beeping?
Your machine is checking that the water has drained before spinning. Your washer will beep if you have used ‘No Spin’ and at the end of the cycle. If your machine is beeping continuously or giving a musical series of beeps, refer to the ‘Before you call for service’ section.
Why is my spin light flashing?
Spin LED light is flashing: If an out-of-balance condition is detected by the washer, the Spin light will blink during the remaining portion of the cycle and will stay illuminated for a short time after cycle completion. In some cases, the washer may not be able to balance the load and spin up to full speed.
Why are the lights flashing on my Nespresso machine?
If you see nespresso lights flashing 3 times it may indicate that descaling mode was activated. To stop the descaling mode, press and hold 3 buttons for 6 seconds until you hear a beeping sound. Nespresso vertuoline blinking twice Open the machine’s top and inspect the capsule
What should I do if my answering machine is not working?
The best option is to reset the machine base after deleting all the messages. Disconnect the AC adapter from the wall and the base and wait for at least two minutes. Then, reconnect the adapter and allow the base to power up. This should fix the problem.
What does the orange light on my pour machine mean?
ORANGE INDICATOR LIGHT – DESCALING. The Indicator Light is lit ORANGE. The machine requires Descaling. These instructions, allow you to reset the machine back to its factory settings – helpful if you experience an issue with the machine, or you have changed the pour levels for example and cannot change them back to their original levels.
Why does my Keurig keep blinking its lights?
This is normally the result of an interrupt to what ever it was working through. This could be in the form of a power change, a break in signal from one of its sensors or its just having a bad day!