Why does my DVD player keep saying loading?
Possible Reasons & Fixes to DVD Player Loading Problem If the DVD player is not loading all discs, then there could be dirty or bad lens and mainboard of the DVD player. Try another disc, if dvd player stuck on loading problem doesn’t happen with another disc, check if the problematic disc is dirty or scratched.
How do I fix my DVD player that wont load?
How to Troubleshoot a Home Theater DVD Player That Won’t Load…
- Unplug your DVD player and keep it powered down for about 60 seconds.
- Wipe off the disc.
- Open your DVD tray and insert the nozzle of the spray can into the player itself.
- Insert a DVD cleaner into the player and run it through the full cycle.
Why does my DVD player not play?
Playback problems with a DVD typically are caused by one of four factors: The DVD is dirty and smudged; the laser lens in the DVD player’s disc drive needs cleaning; the DVD player no longer is tracking properly; or the disc is scratched.
How do you clean a DVD player without a disc?
How to Maintain Your DVD Player
- Remove the top cover screws. If the cover wraps around the unit, there may be more screws to take off.
- Blow off the dust with canned air or a hair dryer set on cool.
- Dampen a foam or lint-free swab with a few drops of lens cleaner.
- Reassemble the cover and put the screws back in.
What to do if your DVD player is not loading?
▪ Try another disc to check if the DVD player is dirty or there are bad lens and mainboards. ▪ If a car portable DVD player is not loading discs, check the tin ribbon wire that connects the optic lens and the mainboard. ▪ Check if the problematic disc is dirty or scratched.
What’s the maximum torque of a DVD player?
The RF-300FA Series. Mabuchi also make the RF-300FA, which is for DVD players. These are the torque-up types. The RF-300FA-11420 has an operating voltage range of 1.7 V to 6 V. Its maximum speed without load is 2900 rpm drawing a current of 0.068 A. Its maximum torque is 22 g•cm.
Why does my DVD player say Uknown disk?
AFTER i RECORD A MOVIE ON THE DISK AND THEN DO AN IMMERDIATE AFTER i RECORD A MOVIE ON THE DISK AND THEN DO AN IMMERDIATE PLAYBACK…IT WORKS GOOD…BUT WHEN i PUT THE SAME DISK IN AT A LATER TIME..THE RECORDER COMES BACK AND SAYS IT IS AN UKNOWN DISK ..i GET T…
Why does my DVD player say it is for the correct region?
The DVD box says it is for the correct region but the disk is not encoded for the region on the box. The polycarbonate material is defective and is filtering the laser light wavelengths and attenuating the signal the pickup is getting to a level that is basically “in the noise” so the device gives up.