Table of Contents
Where is the blower motor control module located?
It’s located inside the dash, often on the opposite side of the steering wheel or inside the engine compartment on the firewall. A blower motor resistor or a blower motor control module is the part that controls the speed of the blower motor.
Where is the blower motor relay located?
under-hood fuse box
The blower motor relay is generally located in the under-hood fuse box or in the under-dash fuse box. A blown fuse can mimic relay failure.
How do I know if my blower motor module is bad?
Here are some of the warning signs of a bad heater blower motor resistor:
- Fan does not work at all, so no air comes out of the vents.
- Fan only works on some speeds and not others.
- Fan only works on the highest speed.
- Fan runs all the time and can’t be controlled with the fan switch.
- You see smoke coming out of the vents.
Why is my blower motor not working?
In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely. Start by checking the blower fuse and HVAC controller fuse.
What happens when blower motor resistor goes bad?
If the resistor shorts or fails, it may cause the blower motor to remain stuck on one fan speed. The heating and air conditioning systems may still function at one speed, however the resistor will have to be replaced in order for full functionality to be restored.
What happens when blower motor relay goes bad?
If you have a faulty blower motor, you may experience low airflow from the vents, even when the fan is on high. There will be no air coming from the vents if your fan isn’t working due to a bad blower motor resistor.
Is there a fuse for the blower motor?
Many vehicles have two fuses for the blower motor, one in the interior fuse block and the other under the hood. The blower motor is usually under the dashboard on the passenger side.
Do all blower motors have a reset button?
Almost every furnace has a reset button, which is typically located inside the blower housing next to the blower motor. The reset button is red or yellow, and it’s usually in a prominent place so it’s easy to see.
How do I reset my blower motor?
How to Find and Reset your Furnace Motor Blower
- Step 1: Turn off the power to the furnace.
- Step 2: Remove the blower compartment cover.
- Step 3: Make sure the blower is completely cooled off.
- Step 4: Locate the reset button.
- Step 5: Press the button in (assuming that this is your issue and that the button has popped).
How much does it cost to replace a blower motor resistor?
Blower Motor Resistor Replacement Cost – RepairPal Estimate. Labor costs are estimated between $44 and $55 while parts are priced between $64 and $82. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
Can I bypass the blower motor resistor?
In the highest speed state, the blower resistor is bypassed completely and the fan is connected directly to the car’s battery, which allows maximum current through the motor. Power to the blower motor is fed through the blower motor resistor, so if it fails or has any issues power can be cut off to the motor.