What does the vacuum line connect to?
A vacuum hose, which can also be referred to as a “line” or a “tube,” is a flexible rubber connection that routes manifold vacuum to various components and accessories. Since vacuum can be used to power everything from a vacuum brake booster to a windshield wiper motor, a vehicle may contain dozens of these hoses.
Where do the vacuum lines go on a quadrajet?
the T: right goes to the Brake booster. left (steel line) goes to kickdown. rear facing is not connected just blocked.
Do you need to hook up vacuum advance?
Plugging your vacuum advance into a direct source will allow it to engage at idle, which is good for a number of reasons. Much like cruise conditions, engines run leaner at idle than they do under load. Again, this means the mixture burns slower and needs an earlier spark to optimize the burn.
Where does the vacuum line go in a Camaro?
Sorry for all the questions, but want to get it right, before firing it up. It is a vortec 383 chevy. Thanks in advance. you should probably hook your transmission’s vacuum line, and your power brake booster line to a vacuum fitting on the intake manifold. Yes, distributer goes to carb.
Where to connect various vacuum accessories to the CARB?
There is no purge valve. If the base of the carb is drawing vacuum the canister is allowing fumes to flow through that line. The ’73 canister has 3 connections. One to the tank, one to the base of the carb and the small one to the port above the throttle blades on the carb. There is no temperature sensor.
Where should TH350 actuator vacuum line connect?
One outlet is for the power brake booster and the other is for the Vacuum Modulator on the transmission. Its entirely possible that your connection is supplying insufficient vacuum to the modulator.
Where are the vacuum ports on an XT?
1) Brake booster – originally connected to the base of the carb (rear). 2) Headlight doors – originally connected to a manifold vacuum port. 3) Vapor canister control line (this port signals the purge valve to open and was originally connected to the small vacuum port near the top of the carb.