Table of Contents
What does it mean when your car tries to start but won t?
If your vehicle won’t start, it’s usually caused by a dying or dead battery, loose or corroded connection cables, a bad alternator or an issue with the starter. It can be hard to determine if you’re dealing with a battery or an alternator problem.
Why does my car cranks long before starting?
When an engine cranks for a long time before it starts, either spark or fuel is missing or weak and each has its own reasons. A bad coolant sensor, a bad throttle position sensor (TPS), a bad fuel pump or a plugged fuel filter can all cause a lean condition causing long cranking times.
Can a bad 02 sensor cause hard starting?
The O2 sensor will not cause the no start. The no start can be caused by the fuel pump or the ignition system. You should check the engine for spark and fuel pressure, when it is not turning on to help narrow the problem down. The ignition system may be the coil, module, or pick up in the distributor.
What to do if your Chevy c1500 won’t start?
126 people found this helpful. Hi, our 1999 CHEVROLET C1500/K1500 is having the same issue. After sittiing for a few hours, we have to crank it and eventually put a little gas or tarting fluid in the throttle body for our truck to start but runs and drives fine once it does start and will start right up after only sitting for about an hour or so.
What to do if your Vortec won’t start?
96 Chevy C1500 5.7L Vortec Truck won’t start, Replaced Fuel Pump, Filter & Has Spark. Hey everyone, I have a 1996 Chevy C1500 with a 5.7L Vortec, I got the truck recently and was told it just needed a Fuel pump, I replaced the Fuel pump, and the Filter, also the pump turns on and there is fuel up at the rail, I pushed the pin and it shot right out.
Why is the fuel pump not working on my Vortec truck?
FYI – If the pass lock isn’t working properly, the computer will not keep the fuel pump on when the key is turned to start and released. 74 people found this helpful. Note: If the battery dies or is disconnected, or the computer is disconnected, this procedure may have to be repeated.