Menu Close

How do you set the timezone on a sharp atomic clock?

Admin

How do you set the timezone on a sharp atomic clock?

  1. Press the “RESET” button on the back of the clock.
  2. Set the time zone by pressing and releasing the “TIME” button on the clock. Press the “UP” button to cycle through the four available United States’ time zones.
  3. Hold down the “TIME” button until the year setting begins to flash.

How do you change the time zone on a sharp atomic clock spc364?

* Hold the [SET] button for 2 seconds until the hour digit flashes, then release the [SET] button. * Press the [ADJUST] button to set the desired hour. * Press the [SET] button again.

How do I turn off the DST on my sharp atomic clock?

When the TIME ZONE flashes, use the UP/DOWN button to select the correct Time Zone. Press the TIME button to confirm. When DST flashes, press the UP/DOWN button to turn this option on or off. Press TIME to confirm.

How do I set the digital clock on my sharp Accu set?

you can slide the mode switch to sec position, press (+) key to have the clock’s second hand move to 12:00 position. 5. slide the mode switch to set position, the hour digit will be flashing. press (+) key or (-) key to adjust the correct hours.

How do I reset the time zone on my atomic clock?

Press and hold the ALARM button for 2 seconds to enter the alarm set mode. Press + or – to adjust, then press ALARM to confirm and move to next feature. ZONE / DST ON / OFF Press to select the current time zone: PST, MST, CST or EST. Hold the ZONE button for 2 seconds to switch from DST ON to DST OFF.

How do I reset my sharp atomic clock?

The clock will automatically leave manual mode after the SET button is not pressed for 6+ seconds. If the clock does not respond to the various function modes, you can reset the clock by pressing the RESET button on the movement case.

What does the wave button on atomic clock?

Wave (Enforced Signal Receipt): This is best done at night when the signal is strongest. Hold the WAVE button down for 3+ seconds. Once the WAVE feature is activated, the hands will automatically reset to the 12:00 position, and the movement will attempt to enforce a signal receipt from Fort Collins, CO.

How to change time zone on sharp atomic clock model spc364?

How to change a timezone on Sharp Atomic Clock Model SPC364? 1 In the Normal Time Display, press the [MODE] button to enter the Alarm Time Mode. 2 Press the [SET] button to set the desired time zone. Refer to the Time Zone map on the display, P=Pacific, M=Mountain, C=Central and E=Eastern. 3 Press the [MODE] to return to the time mode position.

How do you change the hour on a sharp alarm clock?

Insert power cord into a working power outlet. 2.) Move alarm setting from BUZZER to RADIO. 3.) On the back of the clock, move the AM/FM to desired setting. Remove any and all packaging material off of the clock. 3.) Press the MIN button to change the minute. 4.) Press HOUR button until desired hour is displayed.

Where is NIST located on sharp atomic clock?

The signal strength indicator will bink on the display as the clock seeks out the signal. The National Institute of Standards and Technology (NIST) is located in Fort Collins, Colorado.