Table of Contents
How do you bypass the security system on a 2002 Ford Explorer?
First, go to the driver’s side of Your vehicle, and insert the key into the lock. Turn the lock to the right, or to the unlock position. Hold this position and count for 25 to 40 seconds. Doing this will bypass the anti-theft system.
Where is the valet override switch on a 2002 Ford Explorer?
The valet/override switch is a small button under the dash near your knee. This button is either very small and spring-loaded, in which case it will be red or black, or it will be larger and flippable.
How do you bypass the theft system on a 2000 Ford Explorer?
To reset the anti-theft system on a 2000 ford explorer you need to roll down a window and lock all doors from the inside except the drivers, then use the key to lock the drivers door.
How do I get my Ford Explorer out of anti theft mode?
How do you turn off theft light on a Ford Explorer?
To disable anti theft then get in vehicle and close the door. Put key in ignition and turn from off to run 8 times. On the eighth time leave in on position and the theft light will turn off.
How do you reset the security on a 2002 Ford Explorer?
To begin, turn the key in the ignition as if You were trying to start the engine. The engine won’t start since the anti-theft system has been activated. Allow the key to fall back into the ON position so the dashboard lights and radio still work. Leave the key like this for at least 10 minutes.
Where is the valet override?
Typical locations for valet switch: Under the driver’s side dash (mounted in the under-dash covering trim panel or wire-tied to a harness) Mounted in the driver’s side kick panel.
How do I disable anti theft?
Turn the key to unlock your car door, but don’t release it. Hold the key in this position for 20 to 30 seconds. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Some vehicles recognize the key simply by turning the key back and forth in the door lock key cylinder.