Table of Contents
How do I start GW Basic?
To run the program, simply press the F2 key, which is assigned to the RUN command. As you learn more commands, you’ll learn how to use keys F3 through F10. Chapter 4, “The GW-BASIC Screen Editor,” contains more information about keys used in GW-BASIC.
How do you make a 5 pointed star out of paper?
- First fold a square of paper through the middle as shown in the illustration. To look like this.
- Now fold corner A over to point B. To look like this.
- Now fold again. Fold corner A to corner B.
- Now fold left top corner over to approximately point B. To look like this.
- Now cut on an angle.
- Open up and you have a star.
Is GW-BASIC a low level programming language?
GW-BASIC is a dialect of the BASIC programming language developed by Microsoft from IBM BASICA. Since it was included with most versions of MS-DOS, it was also a low-cost way for many aspiring programmers to learn the fundamentals of computer programming. …
How do you cut a 5 point star out of wood?
Once the rectangles are cut, one of the long edges of each piece needs to be cut at a 30 degree angle (or whatever angle you choose). Set the base of the saw for the desired angle of cut and use a straight edge as a guide for the saw to cut along the entire length of the piece of wood.
What do you need to make a 5 point star?
You will need: We’ll be making a three-dimensional star that has a straight ridge, running from the center of the star to the tips of each point. The angle of this ridge can be anything you like, but I’ve found that a 30 degree angle looks great and gives the star a good amount of depth.
How did Betsy make the 5 pointed star?
When the committee protested that these would be too difficult to make, Betsy is said to have taken a piece of paper, folded it deftly, and with a single snip of her scissors, produced a symmetrical five-pointed star, so impressing her audience with this feat of seamstress magic that they readily agreed to her suggestion.
What’s the best way to make a star?
We’ll be making a three-dimensional star that has a straight ridge, running from the center of the star to the tips of each point. The angle of this ridge can be anything you like, but I’ve found that a 30 degree angle looks great and gives the star a good amount of depth.