Table of Contents
How do you change a disc pad?
Steps for changing your brake pads
- Remove the wheel.
- Remove the slider bolt.
- Pivot the caliper up.
- Slide out the old brake pads.
- Replace the retaining clips.
- Slide in the new brake pads.
- Retract the pistons.
- Monitor the brake fluid level.
Is it easy to change discs and pads?
Although each element of replacing brake discs is fairly straightforward, it is a lengthy process and there is a lot which could go wrong. Brakes are vital to the safety of both you and your passengers, so there is no point taking any unnecessary risks.
Do you have to change discs when changing pads?
The answer is YES. For example, the brake discs do not need to be changed if the car is relatively new and there is still a lot of disc life left. They absolutely need to be changed if the discs are unevenly worn or badly scored. Braking force is created by the brake pad and brake disc.
How do you remove brake pads and refit?
- Step 1: Remove Your Wheel. Use the car jack to lift your vehicle until the wheels are off the ground.
- Step 2: Remove Brake Caliper.
- Step 3: Remove Brake Disc.
- Step 4: Install New Brake Disc.
- Step 5: Install New Brake Pads & Caliper.
- Step 6: Refit Wheel.
- Step 7: Test Brakes.
How do you change brake pads UK?
Wear protective gloves and eye safety glasses at all times.
- Step 1 – Remove Your Wheel.
- Step 2 – Remove the Guide Pin Bolt.
- Step 3 – Remove the Brake Pads.
- Step 4 – Check the Brake Disc.
- Step 5 – Tighten the Clamp.
- Step 6 – Apply Grease.
- Step 7 – Fit Brake Pads.
- Step 8 – Test Brake Pads.
What tools do I need to change brake pads and discs?
What Tools Do You Need To Change Brake Pads and Rotors?
- Ratchet and Socket Kit. To fix your vehicle, you must have a socket set.
- Torque Wrench. A torque wrench is a must.
- Brake Pad Spreader or C-Clamp.
- Torx / Allen Set.
- Brake Bleeder Wrench.
- Jack and Jack stands.
- Lug Nut Wrench.
- Gloves.
How long does it take to change discs and pads?
Replacing a pair of brake discs and pads takes between 1 and 3 hours for the front, and the same for the rear.
Can you use old pads on new discs?
We are often asked why brake discs cannot be replaced without replacing the pads at the same time. It is likely that the old brake pads will not be perfectly flat, therefore, and putting them on the new brake discs will mean the profile of the pads will essentially ‘eat’ its way into your nice new discs.