Menu Close

How do you reset the oil light on a 2001 Chevy Venture?

Admin

How do you reset the oil light on a 2001 Chevy Venture?

2001-2005 Chevrolet Venture Change Engine Oil Minder Light Reset

  1. Turn the ignition key to the “ON” position.
  2. Press the TRIP button repeatedly until you see OIL on the display.
  3. Press and hold the TRIP button for several seconds.
  4. Turn the ignition off and start the engine to verify the indicator has been reset.

How do you reset the oil light on a 2000 Chevy Venture?

Follow this procedure to reset the GM oil life system on your Venture Van: Turn the ignition to ON without starting the engine. Fully press and release the accelerator pedal three times within five seconds. • If the CHANGE OIL SOON indicator flashes two times, the system is reset.

How do you reset engine changes?

Hold the Reset Button and Turn the Key

  1. Press and hold the reset button.
  2. Turn the ignition back to the ON position while holding the reset button.
  3. Watch the oil change or maintenance light carefully.
  4. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.

How much oil does a 2004 Chevy Venture take?

The 2004 Chevy venture has an oil capacity of 4.5 Quarts with the filter.

How do I reset my oil change code?

Turn the ignition off, wait a few moments, and then start the engine. Look at the dash to see if the oil light is still flashing or lit. If so, repeat the reset process. If the light is still lit after three reset attempts, contact the manufacturer to learn the correct reset procedure for your vehicle.

What kind of oil does a 2004 Chevy Venture take?

SAE 5W-30
SAE 5W-30 is preferred.

What kind of transmission fluid does a 2004 Chevy Venture take?

Valvoline Synthetic Transmission Fluid Dexron VI 1 Quart.

How to turn off service engine soon light?

NOTE: Some cars have a theft deterrent radio installed on them, so if you disconnect the battery it may end up not working after this procedure. The simplest and the safest way to turn off check engine light soon is by using an OBD2 scanner which can be obtained from any auto shop.

How to reset service engine soon light Paul?

What You Will Need 1. Turn the Ignition to the ON position 2. Press the Accelerator in Quick Succession 3. Release the Accelerator 4. Press and Hold the Accelerator 5. Release the Accelerator 6. Turn OFF the Ignition 7. Start the Car Method 2 1. Disconnect the car battery 2. Drain the Remaining Power 3. Wait for Fifteen Minutes 1.

What causes the check engine soon light to go on?

If the Mass flow sensor cannot get the correct fuel amount to the engine, this may trigger the check engine soon light. Inaccurate fuel injection means that your Mass flow sensor should be replaced. 5. Problem with the Engine light The dashboard circuit may have a wiring problem that keeps the engine light in an ON state.