Table of Contents
- 1 What does the stop light mean on a Clio?
- 2 What is a toxic fume warning light?
- 3 Can I drive with check injection light on?
- 4 How do I reset my car Immobiliser?
- 5 What does it mean when the service indicator light is on?
- 6 What does check injection light mean?
- 7 What does it mean when a Renault light comes on while driving?
- 8 How does the Renault Clio stop and start system work?
- 9 What should I do if my Renault Captur light comes on?
What does the stop light mean on a Clio?
The stop warning light illuminates initially with the ignition and extinguishes once the engine has started. The light illuminate alongside other warnings and messages and is accompanied by an audible sound. If the warning light illuminates, stop the car as soon as it is safe to do so and contact a vehicle technician.
What is a toxic fume warning light?
It restricts the engine revs, and stops you from driving too quickly (above 30mph until the car is fixed) until you get to a garage. The toxic fume light can mean just about anything along the fuel line could need replacing, so I think you might need to take it to a garage for a fault code readout.
Can I drive with check injection light on?
Re: check injection warning light and engine become sluggish Replace the garage, unless you are a DIY person. In the latter case start with OBD. Avoid driving meanwhile, because the engine is trying to minimize the damage by reducing its power on purpose.
What PSI should my Renault Clio Tyres be?
29psi
This tyre placard recommends a minimum tyre pressure of 29psi for the 2018 Renault Clio RS hatchback. This is equal to 200kPa and 2.0 bar. This tyre pressure placard is located on the inside of the drivers door.
How do you bypass the immobilizer on a Renault Clio?
If your Clio does not have a central lock button, depress the accelerator pedal and depress the button at the end of the windscreen wiper switch. Write down the code or keep a memory of it, as you will need it to bypass your Clio’s immobiliser.
How do I reset my car Immobiliser?
Hold down the panic button for five seconds to reset the immobilizer. Next, push the lock button two times and wait ten feet away from the car for ten minutes.
What does it mean when the service indicator light is on?
The service required light is mainly used to remind drivers when it is time to change the oil and filter, but could be used for other fluids or components. In the past, this light was similar to the check engine light and could mean that a fault has been detected by the system.
What does check injection light mean?
Ok.. the fault injection warning is basically and engine management warning message – this usually means your cars ecu has picked up on fault somewhere on the engine itself wether it be a sensor giving out or becoming faulty or wiring to these / a fuel injection system problem usually one of the injectors,intake system …
What does check emissions mean?
Most of the time, when an Emissions Light comes on, it is due to either a sensor or a problem with the exhaust gas recirculation valve. It is also possible that you have a vacuum hose that has become disconnected, or has developed cracks.
What does the stop warning light on a Renault Clio mean?
If the warning light illuminates whilst driving, accompanied by a STOP warning message and a audible beep, this indicates an overload in the electrical circuits. Stop when safe to do so and seek help from an approved technician. The stop warning light illuminates initially with the ignition and extinguishes once the engine has started.
What does it mean when a Renault light comes on while driving?
Consult authorised Renault technician. Light illuminates when ignition is turned on and goes out a few seconds later. IF the light comes on whilst driving, it indicates there is water in the diesel. Contact should be made with an authorised Renault vehicle technician as soon as possible.
How does the Renault Clio stop and start system work?
This is of benefit when driving in areas where you would like to keep to a specific speed limit. The Renault Clio automatic engine stop and start system helps to reduce fuel consumption and lower exhaust emissions. Stop and start is activated automatically when the vehicle is started, but can be manually switched off.
What should I do if my Renault Captur light comes on?
This comes on when the ignition is switched on. If it turns red, stop and let the engine idle for a minute or two. The temperature should lower and the warning light should return to a blue colour. If not, stop the engine. Let the engine cool down before checking the coolant.