Table of Contents
- 1 How do I know if my cam solenoid is bad?
- 2 What causes a camshaft actuator to go bad?
- 3 How much does it cost to replace a camshaft position actuator solenoid?
- 4 Can you drive with a bad camshaft position actuator solenoid?
- 5 Why does the camshaft position actuator trouble code keep returning?
- 6 How to test the camshaft position of a battery?
How do I know if my cam solenoid is bad?
A glowing check engine light, stalling, poor acceleration and bad fuel mileage are all possible signs your camshaft position sensor may be failing.
What causes a camshaft actuator to go bad?
The camshaft position sensor gathers information about the vehicle’s camshaft speed and sends it to the vehicle’s engine control module (ECM). Over time, the camshaft position sensor can fail, or become worn down, due to accidents or normal wear and tear.
How much does it cost to replace a camshaft actuator?
The average for Camshaft Position Actuator is $665
| Repair Type | Zip | Cost |
|---|---|---|
| Camshaft Position Actuator | 96447 | $181 |
| Camshaft Position Actuator | 64713 | $315 |
| Camshaft Position Actuator | 36202 | $2848 |
| Camshaft Position Actuator | 52804 | $500 |
Can I drive my car with a bad camshaft position sensor?
Yes, it is safe to drive with a bad camshaft sensor. However, the performance of your engine will not be as good and fuel consumption may increase. In some cases, the camshaft may need replacement if there are any other symptoms of failure on this component.
How much does it cost to replace a camshaft position actuator solenoid?
Can you drive with a bad camshaft position actuator solenoid?
Yes, it is safe to drive with a bad camshaft sensor. If a camshaft position sensor is not repaired, then you will likely experience more and more issues with your vehicle’s ignition system that could lead up to very expensive repairs.
How do you check for a bad camshaft sensor?
Touch one of your meter probes to either one of the sensor wires and the other to the other wire. Check your meter display and compare your reading to your manual specifications. In most cases, you’ll see a fluctuating signal between 0.3 volts and 1 volt. If there’s no signal, you have a bad sensor.
How is the camshaft position actuator solenoid test done?
To find out if the camshaft position actuator solenoid is defective or not we’re gonna’ remove it and bench test it. What the test involves is applying battery power and battery Ground to the camshaft position actuator solenoid and seeing if the spool valve within the solenoid moves.
Why does the camshaft position actuator trouble code keep returning?
If the camshaft position actuator solenoid trouble code keeps returning then you can conclude that the trouble code is due to another condition. For more suggestions on troubleshooting the camshaft position actuator trouble code see: The Camshaft Position Actuator Solenoid Trouble Code Does Not Go Away.
How to test the camshaft position of a battery?
These are the test steps: Disconnect and remove the camshaft position actuator solenoid from its location on the cylinder head. Connect terminal A to battery power using a jumper wire.